• Push the left arrow button, and the thruster moves the boat to
port.
• Push the right arrow button, and the thruster pushes the boat
to starboard.
• Push the centre (twin arrow) buttons to activate both bow and
stern thruster simultaneously in opposite directions. The boat
will start to rotate about its own axis. (Requires both bow and
stern thrusters installed.)
Orange light
Low voltage at the electronic unit is indicated by an orange light
in the
“POWER” indicator.
Red light
The indicator will quickly blink red
in case of system faults and
slowly blink red together with short sounds if the remote is unable to
communicate with the electronic unit (out of range.)
If the thruster is overloaded and requires time to cool down, this will
also be indicated by a quickly blink red
.
These error messages are shown when buttons are pushed.
6. Upgrade to wireless remote control.
XForce Thrusters can optionally be delivered with 3 different electronic control units (MCU).
1. Relay box
2. Relay box with integrated radio receiver.
3. Transistor-controlled power electronics with integrated radio receiver that replace the
conventional power contactor. (Not yet available, developing process started.)
The new electronic unit contains no open contacts and is very flexible as regards voltage.
The control electronics are software based and feature an integrated radio receiver that
communicates with the wireless remote control and built in system to protect the thruster
motor and electronic components.
IMPORTANT! Turn off the thruster main switch when not in use. The
radio receiver current consumption will be approx 3.5 W as long as it is
turned on.
6.1 Antenna installation
If wireless remote control option is to be implemented after choosing
option 2 or 3.
If not already installed, the MCU must be fitted with an antenna.
The remote control and electronic unit must also be coded/taught
electronically to communicate with each other.
Remove the left rubber cover. Then push the antenna through the
cover (on one side).
While holding down the antenna connector handle, push the antenna
all the way down into the bottom of the clamp. Release the handle and
the antenna is fixed in place.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji